Dr. Fixit Repellin WR for Waterproofing – Silicone Based Water Repellent for Exterior Brick & Stone Masonry Surfaces

Dr. Fixit Repellin WR Waterproofing is composed of Siloxane & Silane polymers dispersed in high boiling point solvent. It is used as water repellent of concrete & cementitious vertical walls of building because it penetrate deeply into the substrate & provides an effective water repellent protective coating. It does not change the appearance of the substrate & is UV resistant.

Typical Applications

Water repellent treatment for –

• Clay brick surfaces
• Concrete, mortar
• Mangalore tiles
• Natural and artificial stones

Features

Ease of application – Ready to use, brushable or spray applied

Staining – Clear coating does not stain the treated surface.

Appearance – Does not change the appearance of exterior decorative coating.

Economical – Cost effective.

Penetration – Due to low viscosity penetration is high, which provides the hydrophobic zone.

• Also Read: Dr. Fixit Pidiproof LW+ Integral Liquid Waterproofing Compound for Concrete and Plaster

Packaging

1, 10 & 225 litre

Method of Application – Dr. Fixit Repellin WR for Waterproofing

Surface Preparation

1. Surface should be dry and free from all debris, dirt, oil, grease, wax and all other contamination, which could prevent penetration.

2. Clean the saturated dirt of surface by thorough wire brushing, cleaning with compressed air followed by water washing.

3. De grease oil & grease by using appropriate solvents.

4. Allow the surface to dry completely before the application.

5. Seal the cracks using Dr. Fixit Crack-X products.

Application

1. Apply one liberal coat of Dr. Fixit Repellin WR, by brushing evenly on the prepared surface.

2. Apply second coat wet on wet, to improve the penetration rate & performance.

3. Allow it to dry for 24 hrs.

Precautions & Limitations

• Do not dilute.

• Close the container lid properly after use

• Before applying over the natural stones like sand stone, slate or Dhollpur sampling should be done on a small area to check its suitability.

• Before taking up application on a large area, it is advisable to check the performance of the product on a relatively small area.

Technical Information – Dr. Fixit Repellin WR for Waterproofing

Theoretical Coverage – Dr. Fixit Repellin WR for Waterproofing

On porous substrate 5–6 Sq meter / litre / coat. & on low porous substrate 7 – 8 Sq meter/ litre/ coat.

Shelf Life

Shelf life is 18 months from the date of manufacturing in unopened condition. Store in a cool & dry place.

Health & Safety

• Use rubber hand gloves & safety goggles, while using Dr. Fixit Repellin WR.

• In case of contact with skin, wash with plenty of water.

• Keep out of reach of children’s.

• Do not smoke during application.

Check Price on Amazon – Dr. Fixit Repellin WR for Waterproofing